Dell PowerEdge E07S Series Owner's Manual page 47

Table 1-3. System Messages (continued)
Message
Thermal sensor
not detected on
x.
Time-of-day
clock stopped.
Time-of-day not
set - please run
SETUP program.
Timer chip
counter 2 failed.
TPM
configuration
operation
honored. System
will now reset.
TPM
configuration
operation is
pending. Press
(I) to Ignore OR
(M) to Modify to
allow this change
and reset the
system.
WARNING:
Modifying could
prevent
security.
TPM failure.
Causes
A memory module without a
thermal sensor is installed in
the specified memory slot.
Faulty battery or faulty chip. See "Troubleshooting the
Incorrect Time or Date
settings; faulty system
battery.
Faulty system board.
A TPM configuration
command has been entered.
The system will reboot and
execute the command.
This message displays during
system restart after a TPM
configuration command has
been entered. User
interaction is required to
proceed.
A Trusted Platform Module
(TPM) function has failed.
Corrective Actions
Replace the memory
module. See "System
Memory" on page 106.
System Battery" on page 150.
Check the Time and Date
settings. See "Using the
System Setup Program and
UEFI Boot Manager" on
page 53. If the problem
persists, replace the system
battery. See "System Battery"
on page 130.
See "Getting Help" on
page 169.
Information only.
Enter I or M to proceed.
See "Getting Help" on
page 169.
About Your System
47