Section 8 - Operating Instructions And Function Tests; Functions Tests - Mec Micro26-XD Operator's Manual

Section 8 - Operating Instructions and Function Tests

DO NOT operate this machine until you have read and understood this manual, have
performed the Workplace Inspection, Pre-Start Inspection and Routine Maintenance, and have
completed all the test operations detailed in the Operating Instructions section.
This section provides instructions and tests for each function of machine operation. Follow all safety
rules and instructions. The operator must conduct inspections and a Functions Test of the machine
before each work shift to check that all machine systems are working properly.
Test the machine on a firm level surface with no debris, drop-offs, potholes or overhead obstructions.
Perform each step outlined in this section.
This machine shall only be operated by trained and authorized personnel. If multiple operators use
this machine, all must be trained, qualified and authorized to use it. New operators must perform a
Pre-Start Inspection and Functions Test prior to operating the machine.
Operators must comply with all employer and job site rules and governmental regulations regarding
the use of personal protective equipment.
DO NOT use a machine that is malfunctioning. If any function does not perform as described, tag the
machine and remove for repair by a qualified service technician. After repairs are completed, a Pre-
Start Inspection and Functions Test must be performed before using the machine.
ART_6091
WARNING
Prestart
Perform a Pre-start Inspection (see page 34). Check the red Emergency Stop
buttons at both the lower control and platform controls, pull them both out to reset.
Check the red Main Power/Lower Emergency Stop button. Must be in the On
position (pulled out).
Functions Test
1. Select a test area that is firm, level and free of obstruction.
2. Be sure the battery pack is connected.
3. Pull the main power switch to the On position (pulled out).
At the Ground Controls
1. Pull the red Emergency Stop button out to the On position (pulled out) at both the ground and
Page 19

Functions Tests

Functions Tests
Check the area above and around the machine for obstructions and
electrical power lines before operating the machine. The machine must
have space to allow full elevation of platform.
Micro26 - XD - Operator's Manual - 96493
October 2024
ART_3353
ART_5231
ON
OFF
Main Power/ Lower Emergency
Stop Switch