Mec Micro26-XD Operator's Manual page 12

Section 4 - Hazards
DO NOT exceed the maximum platform capacity. The weight of options and
accessories will reduce the rated platform capacity and must be factored into
the total platform load. Refer to the decals on the options.
DO NOT elevate the platform when the machine is on a surface that is soft
and/or on a slope.
DO NOT elevate the platform unless the machine is on a firm, level surface.
DO NOT depend on the tilt alarm as a level indicator. STOP if the tilt alarm
sounds and the red light illuminates when the platform is raised. Use extreme
caution to lower the platform. Move the machine to a firm, level surface.
Driving: DO NOT drive the machine on a slope that exceeds the maximum
uphill, downhill or side slope rating. Slope rating applies to machines in the
stowed position.
Driving in stowed position: Use extreme care and reduce speed when
driving across uneven terrain, debris, unstable or slippery surfaces, and near
holes or drop-offs.
Driving with the platform elevated: DO NOT drive on or near uneven terrain,
unstable surfaces, curbs, drop-offs or other hazardous conditions. DO NOT
drive the machine faster than 0.5mph (0.8km/h) while elevated.
DO NOT push off or pull toward any object outside the platform. DO NOT
push the machine or other objects with the platform. DO NOT contact adjacent
structures with the platform.
DO NOT tie the platform to adjacent structures.
DO NOT use the platform controls to free a platform that is caught, snagged or
otherwise prevented from normal motion by an adjacent structure.
DO NOT elevate the platform when wind speeds are in excess of 28mph
(12.5m/s). If wind speeds exceed 28mph (12.5m/s) when the platform is
elevated, carefully lower the platform and discontinue operation.
DO NOT increase the surface area of the platform (i.e. cover the rails with tarp or plywood). Increased
surface area exposed to the wind will decrease machine stability.
DO NOT attach overhanging loads or use the machine as a crane. DO NOT place loads outside the
platform perimeter.
Page 8
Tip-over Hazards
Maximum Allowable Side Force
45lbs (200N) per person
Micro26 - XD - Operator's Manual - 96493
October 2024
Art_2828
Art_2834
Art_2833
Art_2831
Art_2832