MICRO-EPSILON optoCONTROL 2700 Quick Manual page 6

Page | 4
This will open up a menu like below. Make sure that the subnet is set correctly to match what
we want the devices subnet to be. In the case of this example we have set it to 255.255.255.0.
Hit okay to apply the changes and close out of the network settings. If the subnet was not
already what it was supposed to be set to, close out and reopen BootP. At this point once BootP
is open, unplug the ODC2700 and replug it into the Ethernet adapter. DHCP packets are sent by
the device to discover the IP, but over time they are sent less and less frequently. By replugging,
the DHCP packets are received immediately and a device should populate in the top section of
the program. Make sure that the mac address of the device matches with the sensor you have,
and then set the IP address you want to set the device to. Give it a name and hit okay.