Basic Operation - Icom IC-725 Instruction Manual

17
О
5-1 558 ОРЕВАПОМ
BASIC OPERATION
[ATT]
OUT position
(p. 15)
TRANSMIT
[NB]
OUT position
(р. 15)
OUT position
(p. 15)
(p. 15)
(1) SSB RECEIVING
1) Set controls and switches as described on p. 13.
2) Push [POWER] IN to activate the transceiver.
` 3) Select the desired operating band. (See p. 13)
4) Push [SSB].
e USB is automatically selected on bands above 7 MHz.
LSB is automatically selected on bands below 10 MHz.
ePush [SSB] again to select the opposite side of the side
band.
5) Adjust [AF] as desired. (See p. 15)
6) Adjust [SOL], if needed. (See p. 15)
7) Rotate the MAIN DIAL to receive a signal.
8) Use the controls and switches described on p. 15 for
better receiving.
[SSB]
Push [SSB]
OUT position
[SPLIT]
OFF
(pgs. 16, 21)
Г" МЕОА i"
ob
[RIT]
OFF
(pgs. 15, 21)
[TUNER]
Activates only
when the AH-3 is
connected. (p. 10)
(2) SSB TRANSMITTING
NOTE: Listen before you transmit to prevent inter-
ference.
1) Push the PTT switch on the microphone or push
[TRANSMIT] IN to transmit.
2) Speak naturally into the microphone.
e When you transmit a signal, the meter needle moves.
3) Adjust [RF POWER] to the desired output power.
(See p. 16)
4) Adjust [MIC], if needed. (See p. 16)
5) Release the PTT switch to return to receiving.