NSD ABSOCODER NCV-20NDNMP Specifications & Instruction Manual page 24

6. SWICH SETTING OF THE CONVERTER
Explains each switch of the NCV-20NDN.
6-1. DeviceNet Setting
6-1-1. Node address and baud rate setting
Set the node address and baud rate by the DeviceNet setting switch on the panel.
DeviceNet setting switch
Node address
Baud rate
● Node address (NA)
Setting range: 0-63
Setting method: 1-32 (2
Setting example: Turn ON "1 (SW6)" "4 (SW4)" when setting the node address 5.
Panel display
Numeric value
significance
Note
The node address should not duplicate with the master or slave unit.
● Baud rate (DR)
The setting range is the following three.
Baud rate
Setting is prohibited
-2 ) is set by the binary.
０ ５
32 16
2 2
5 4
Panel display
1
125 kbps OFF
250 kbps OFF
500 kbps ON
ON
All setting is OFF when shipping from the factory.
NA
8 4 2 1
2 2 2 2
3 2 1 0
DR
0
OFF
ON
OFF
ON
18