Default Stp, Rstp, And Mstp Configuration; Table 9 Default Stp, Rstp, And Mstp Configuration; Table 10 Default Mstp Configuration; Table 11 Default 10-Gigabit Ethernet Cee Interface-Specific Configuration - Dell 53-1002116-01 Administrator's Manual

6

Default STP, RSTP, and MSTP configuration

Default STP, RSTP, and MSTP configuration

Table 9
TABLE 9
Parameter
Spanning-tree mode
Bridge priority
Bridge forward delay
Bridge maximum aging time
Error disable timeout timer
Error disable timeout interval
Port-channel path cost
Bridge hello time
Flush MAC addresses from the VLAN FDB
Table 10
TABLE 10
Parameter
Cisco interoperability
Switch priority (when mapping a VLAN to an
MSTP instance)
Maximum hops
Revision number
Table 11
TABLE 11
Parameter
Spanning tree
Automatic edge detection
Path cost
Edge port
Guard root
Hello time
Link type
Port fast
Port priority
CEE interface root port
CEE interface BPDU restriction
50
lists the default STP, RSTP, and MSTP configuration.
Default STP, RSTP, and MSTP configuration
lists the switch defaults that apply only to MSTP configurations.
Default MSTP configuration
lists the switch defaults for the 10-Gigabit Ethernet CEE interface-specific configuration.
Default 10-Gigabit Ethernet CEE interface-specific configuration
Default setting
By default, STP, RSTP, and MSTP are disabled
32768
15 seconds
20 seconds
Disabled
300 seconds
Standard
2 seconds
Enabled
Default setting
Disabled
32768
20 hops
0
Default setting
Disabled on the interface
Disabled
2000
Disabled
Disabled
2 seconds
Point-to-point
Disabled
128
Allow the CEE interface to become a root port.
Restriction is disabled
Dell Converged Enhanced Ethernet Administrator's Guide
53-1002116-01