Dell 53-1002116-01 Administrator's Manual page 128

10
Converged Enhanced Ethernet map configuration
Defining a priority-table map
To define a priority-table map, perform the following steps from Privileged EXEC mode.
1. Enter global configuration mode.
2. Specify the name of the CEE map to define. In this example 'test' is used.
3. Define the map.
4. Enter the copy command to save the running-config file to the startup-config file.
Applying a CEE provisioning map to an interface
To apply a CEE provisioning map, perform the following steps from Privileged EXEC mode.
1. Enter global configuration mode.
2. Specify the 10-gigabit Ethernet interface. In this example, 0/2 is used.
3. Apply the CEE map on the interface.
4. Enter the copy command to save the running-config file to the startup-config file.
Verifying the CEE maps
To verify the CEE map, perform the following steps from Privileged EXEC mode.
1. Enter global configuration mode.
2. Verify the CEE map provisioning for a specified name.
110
switch#configure terminal
switch(config)#cee-map test
switch(config-ceemap)#priority-table 1 1 1 0 1 1 1 15.0
switch#copy running-config startup-config
switch#configure terminal
switch(config)#interface intengigabitethernet 0/2
switch(conf-if-te-0/2)#cee default
The following example applies the CEE provisioning map on an interface.
switch:root>cmsh
switch>enable
switch#configure terminal
Enter configuration commands, one per line.
switch(config)#interface intengigabitethernet 0/2
switch(conf-if-te-0/2)#cee default
switch(conf-if-te-0/2)#exit
switch(config)#end
switch#copy running-config startup-config
switch#configure terminal
switch(config)#show cee maps default
End with CNTL/Z.
Dell Converged Enhanced Ethernet Administrator's Guide
53-1002116-01