Configuring Sflow On Specific Interfaces - Dell 53-1002116-01 Administrator's Manual

To disable sFlow on a specific interface, perform the following steps in global configuration mode.
1. Enter interface mode for the port
2. Disable sFlow on the interface.
3. Confirm the sFlow configuration status on the specific interface.

Configuring sFlow on specific interfaces

You can enable sFlow and configure the polling interval and sample rate for a specific interface
port on the switch.
To customize sFlow on an interface, perform the following steps from Privileged EXEC mode.
1. Enter the interface command to specify the CEE interface type and slot/port number.
2. Enable sFlow for the interface.
3. Configure the sFlow polling interval.
4. Set the sFlow sample-rate.
5. Confirm the sFlow configuration status on the specific interface.
Dell Converged Enhanced Ethernet Administrator's Guide
53-1002116-01
switch(config)#interface intengigabitethernet 0/12
switch(conf-if-te-0/12)f#no sflow enable
switch(conf-if)#exit
switch(config)#exit
switch#>show sflow interface intengigabitethernet 1/12
switch(config)#interface extengigabitethernet 1/16
switch(conf-if-te-0/1)#sflow enable interface
switch(conf-if-te-1/16)#sflow polling-interval 135
switch(conf-if-te-1/16)#sflow sample-rate 8192
switch(conf-if-te-1/16)#exit
switch(config)#exit
switch#>show sflow interface extengigabitethernet 1/16
te 1/16
Configured sampling rate :8192
Actual sampling rate :8192
Counter polling interval :135
Samples rcvd from h/w :33
Interface-specific administrative tasks for sFlow
12
117