Default Acl Configuration; Acl Configuration Guidelines And Restrictions; Acl Configuration And Management; Creating A Standard Mac Acl And Adding Rules - Dell 53-1002116-01 Administrator's Manual

9

Default ACL configuration

MAC ACLs are supported on the following interface types:
•
•
•
Default ACL configuration
Table 15
TABLE 15
Parameter
MAC ACLs

ACL configuration guidelines and restrictions

Follow these ACL configuration guidelines and restrictions when configuring ACLs:
•
•

ACL configuration and management

You need to enter either the copy running-config startup-config command or the write memory
command to save your configuration changes to Flash so that they are not lost if there is a system
reload or power outage.
NOTE
To see the minimum configuration required to enable FCoE on the Dell M8428-k switch, refer to
Chapter 3, "Initial FCoE and CEE

Creating a standard MAC ACL and adding rules

NOTE
You can use the resequence command to change all the sequence numbers assigned to the rules
in a MAC ACL. For detailed information, see
page 90.
To create a standard MAC ACL and add rules, perform the following steps from Privileged EXEC
mode.
1. Enter the configure terminal command to access global configuration mode.
2. Create a standard MAC ACL and enter ACL configuration mode.
88
Physical interfaces
Logical interfaces (LAGs)
VLANs
lists the default ACL configuration.
Default MAC ACL configuration
The order of the rules in an ACL is critical. The first rule that matches the traffic stops further
processing of the frames.
Standard ACLs and extended ACLs cannot have the same name.
Default setting
By default, no MAC ACLs are configured.
Configuration".
"Reordering the sequence numbers in a MAC ACL"
Dell Converged Enhanced Ethernet Administrator's Guide
on
53-1002116-01