2. Apply an LLDP profile to the interface.
3. Configure the FCoE priority bits for an interface. The value is specified as 0x0-0xff.
4. Configure the DCBX version for an interface for CEE. For detailed information on these version
5. Enter the copy command to save the running-config file to the startup-config file.
Clearing LLDP-related information
To clear LLDP-related information, perform the following steps from Privileged EXEC mode.
1. Use the clear command to:
Displaying LLDP-related information
To display LLDP-related information, perform the following steps from Privileged EXEC mode.
1. Use the show lldp neighbors command to:
Dell Converged Enhanced Ethernet Administrator's Guide
53-1002116-01
The following example applies the LLDP profile "network_standard" to the current interface.
switch(conf-if-te-0/10)#lldp profile network_standard
switch(conf-if-te-0/10)#fcoe-priority-bits 0x0-0xff
command keywords, see
"DCBX interaction with other vendor devices"
is to automatically detect the DCBX version.
switch(conf-if-te-0/10)#lldp version cee
switch(conf-if-te-0/10)#exit
switch(config)#end
switch#copy running-config startup-config
•
Clear LLDP neighbor information.
switch#clear lldp neighbors intengigabitethernet 0/1
•
Clear LLDP statistics.
switch#clear lldp statistics intengigabitethernet 0/1
•
Display LLDP general information.
switch#show lldp
•
Display LLDP interface-related information.
switch#show lldp interface intengigabitethernet 0/1
•
Display LLDP neighbor-related information.
switch#show lldp neighbors interface intengigabitethernet 0/1 detail
LLDP configuration and management
on page 79. The default
8
85