Table 3 Cee Cli Command Modes - Dell 53-1002116-01 Administrator's Manual

2
CEE Command Line Interface
NOTE
At system startup, if you try to enter Privileged EXEC mode before the system has fully booted, the
following message is displayed:
%Info: Please wait. System configuration is being loaded.
After the system has fully booted, a RASLOG message indicates that the CEE CLI is ready to accept
configuration commands.
TABLE 3
Command
mode
EXEC
Privileged
EXEC
Global
configuration
Interface
configuration
Protocol
configuration
16
CEE CLI command modes
Prompt
switch>
switch#
switch(config)#
Port-channel:
switch(conf-if-po-63)#
10-Gigabit Ethernet (CEE port):
switch(conf-if-te-0/1)#
VLAN:
switch(conf-if-vl-1)#
LLDP:
switch(conf-lldp)#
Spanning-tree:
switch(conf-mstp)#
switch(conf-rstp)#
switch(conf-stp)#
How to access the command mode
Enter the cmsh command at the
Fabric OS prompt after you have
logged in as an appropriate user.
From the EXEC mode, enter the
enable command.
From the EXEC mode, enter the
configure terminal EXEC command.
From the global configuration mode,
specify an interface by entering one
of the following interface types:
•
interface port-channel
•
interface intengigabitethernet
•
interface vlan
From the global configuration mode,
specify a protocol by entering one of
the following protocol types:
•
protocol lldp
•
protocol spanning-tree mstp
•
protocol spanning-tree rstp
•
protocol spanning-tree stp
Dell Converged Enhanced Ethernet Administrator's Guide
Description
Display running system
information and set
terminal line
parameters.
Display and change
system parameters.
Note that this is the
administrative mode
and also includes EXEC
mode commands.
Configure features that
affect the entire switch.
Access and configure
individual interfaces.
Access and configure
protocols.
53-1002116-01