Configuring A Stateful Ha Pair - Dell SonicWALL NSA E8510 Getting Started Manual

Configuring a Stateful HA Pair

This section provides instructions for configuring a pair of Dell
SonicWALL NSA E8510 appliances for high availability (HA).
This section is relevant to administrators following deployment
Scenario B.
This section contains the following sub-sections:
• Initial High Availability Setup
• Configuring High Availability
• Configuring Advanced HA Settings
• Configuring HA Monitoring Settings
• Synchronize Settings - page 41
• HA License Configuration Overview
• Associating Pre-Registered Appliances
SonicWALL NSA E-Class 2
SonicWALL
HA / Failover Pair
Network Security Appliance
SonicWALL NSA E-Class 1 HA
Network Security Appliance
X0
Local Network
- page 38
- page 39
- page 39
- page 41
- page 42
- page 43
E5500
HA X0 X1
HA Link
E5500
Internet
X1
Initial High Availability Setup
Before you begin the configuration of HA on the Primary Dell
SonicWALL security appliance, perform the following setup:
• On the bottom panel of the secondary Dell SonicWALL
security appliance, locate the serial number and write the
number down. You need to enter this number in the High
Availability > Settings page.
• Verify that the primary and secondary Dell SonicWALL
security appliances are registered, running the same SonicOS
versions.
• Make sure the primary and secondary Dell SonicWALL
security appliances' LAN, WAN and other interfaces are
properly configured for failover.
• Connect the HA ports on the primary and secondary Dell
SonicWALL appliances with a CAT6-rated crossover cable
(red crossover cable). The primary and secondary Dell
SonicWALL security appliances must have a dedicated
connection using the HA interface. Dell SonicWALL
recommends cross-connecting the two together using a CAT
6 crossover Ethernet cable, but a connection using a
dedicated 100Mbps hub/switch is also valid.
Configuring a Stateful HA Pair | 38