Installing A Device In The Nec Versabay Iii - NEC VERSA SXI Manual
Hide thumbs
Also See for VERSA SXI:
- Release note (8 pages) ,
- Using (2 pages) ,
- Service and reference manual (104 pages)
Table of Contents
Advertisement
6.
Pull the device out of the system.
Note
casing catches on the inside of the latch.
Installing a Device in the NEC VersaBay III
Use the following steps to install a device in the NEC VersaBay III.
Your system must be powered on but not in a sleep state or powered off before
removing or inserting devices in the NEC VersaBay III.
Use the NEC VersaBay III Swap utility or power off the system.
1.
2.
Close the LCD panel and turn the system upside down.
Locate the NEC VersaBay III release lock and release latch on the bottom of the
3.
unit.
Slide the lock to the unlocked position, if necessary.
4.
Slide the latch toward the rear of the system and hold it.
5.
6.
Align the device in the NEC VersaBay III and push it in until it locks into place.
If you release the latch before completely removing the device, the device
Removing the device
Using the System Drives and Bays 5-5
Advertisement
Table of Contents
