Installing A Device In The Nec Versabay Iii - NEC VERSA LXI - VERSION 10-2000 Manual

Note
casing catches on the inside of the latch.

Installing a Device in the NEC VersaBay III

Use the following steps to install a device in the NEC VersaBay III.
Your system must be in a sleep state or powered off before removing or inserting
devices in the NEC VersaBay III.
Use the NEC VersaBay III Swap Utility to put your system into a sleep state, or
1.
power off the system.
Close the LCD panel and turn the system upside down.
2.
Locate the NEC VersaBay III release lock and release latch on the bottom of the
3.
unit.
4. Slide the lock to the unlocked position, if necessary.
Slide the latch toward the battery bay and hold it.
5.
Align the device in the NEC VersaBay III and push it in until it locks into place.
6.
If you release the latch before completely removing the device, the device
Releasing the device
Using the System Drives and Bays 5-7