The Scsi Configuration Driver; Using The Driver - NEC VERSA DOCKING STATION 4000 Manual

The SCSI Configuration Driver

Using the Driver

3-18 Setting Up and Using the Software
Type the following at the DOS prompt and press
copy CONDS.SYS CONFIG.SYS
Dock your NEC Versa and reboot the system. The
3.
docking station configuration will be used.
To switch to the mobile configuration, copy the mobile
4.
system files, undock the NEC Versa, and reboot.
Your Docking Station 4000 comes with an external as well
as an internal SCSI port. Plug and Play systems, like the
NEC Versa 4000, take control of this port and its settings.
However, if your system is a non-Plug and Play system,
you may need to specify some settings for the port. The
SCSI Configuration driver included with the Setup utility
provides a means for specifying port settings.
If you have a Plug and Play system, you do
not need to use the SCSI Configuration driver. You
system automatically assigns the addresses and
interrupts to use.
The SCSI port on the back of the docking station has the
following power-on defaults:
n
SCSI Port: Enabled
n
I/O Address: 0140-15Eh
n
IRQ: Enabled
n
IRQ: 10
n
DMA: Enabled
n
DMA: 7.
.
Enter