Ms-Dos Version - NEC VERSA DOCKING STATION 4000 Manual

MS-DOS Version

The hard disk drive that came with your NEC Versa should
have MS-DOS 6.0 or above already installed. The
subdirectories and information modified during Docking
Station 4000 software installation are also in place for the
setup utility to locate.
Setting up the software as described here creates a configu-
ration called "Docking Station 4000" that your NEC Versa
can use when it is connected to the Docking Station 4000.
When the NEC Versa is not docked, you can specify the
original NEC Versa configuration, called "Mobile."
Setting up dual configurations requires the following:
n
Checking the level of MS-DOS installed on your NEC
Versa.
n
Running the Docking Station 4000 Setup utility.
You must perform software setup on each
hard disk that you plan to use with the Docking
Station 4000.
Check the MS-DOS version installed on your hard disk
drive as follows:
1. Exit Windows, if you are not at the DOS prompt.
2. From the DOS prompt, type
that the MS-DOS version displayed is 6.0 or higher.
If your system is running an earlier version of MS-DOS,
you must upgrade to Version 6.0 or higher.
ver and press
Setting Up and Using the Software 3-3
Enter . Verify