Switching Between Configurations - NEC VERSA DOCKING STATION 4000 Manual

Switching between Configurations

1. Type the following command at the DOS prompt (C:>)
and press
Enter
copy AUTOEXEC.BAT AUTOMO.BAT
Type the following command at the DOS prompt and
2.
press Enter .
copy CONFIG.SYS CONMO.SYS
Dock your NEC Versa on the docking station. Follow
3.
the instructions in your NEC Versa user's guide to cre-
ate a docked configuration.
After you reboot your system to activate the docked con-
4.
figuration, copy the new system files by typing the fol-
lowing at the DOS prompt and pressing
copy AUTOEXEC.BAT AUTODS.BAT
Type the following command at the DOS prompt and
5.
press Enter .
copy CONFIG.SYS CONDS.SYS
Once you copy the system files as described in the pre-
ceding section, you can switch between configurations as
follows. You only need to follow this procedure when you
want to change to the other configuration. The configuration
you choose will remain the default until you change it.
While your system is still on, exit Windows and go to
1.
the DOS prompt.
Copy the configuration file you want to use and rename
2.
it as the active file. (The active system files are:
AUTOEXEC.BAT and CONFIG.SYS.) To do so, type
the following at the DOS prompt and press
following examples copy the docking station system files
to initiate the docking station configuration.)
copy AUTODS.BAT AUTOEXEC.BAT
.
Setting Up and Using the Software 3-17
.
Enter
. (The
Enter