Table of Contents
Advertisement
4.
Align and connect the other end of the cable to the parallel port on
the device. Lock the connector clips.
Connect the power cable to the printer and a properly grounded wall
5.
outlet.
Turn on power to the system and the printer.
6.
NOTE
instructions that came with your printer for printing information.
Serial Devices
To install a serial device such as a printer or an external modem, you need a
cable with a female 9-pin connector.
NOTE
ate printer driver through the Windows Control Panel. See the online
Windows QuickStart Guide or Using Windows 95 for instructions on
using the Control Panel.
Follow these steps to connect a serial device to your NEC Versa 2000.
Check that both the NEC Versa 2000 and the device power are off.
1.
Open the left-rear port cover and locate the serial port.
2.
3.
Align and connect the 9-pin connector with the serial port on the system.
Secure the connection with the screws provided.
4.
Align and connect the other end of the cable to the appropriate port on
the device. Secure the connections with the screws provided.
Connect the power cable to the device and a properly grounded wall out-
5.
let.
Turn on power to the system and the device.
6.
Check that the printer is online before you try to print. See the
When you connect a printer, be sure you install the appropri-
Learning to Use the Hardware 2-11
Advertisement
Table of Contents
