Table of Contents
Advertisement
Parallel Printers
To install a parallel printer, you need a cable with a male 25-pin connector
for the system and, for most parallel printers, a Centronics®-compatible 36-
pin connector.
NOTE
ate printer driver through the Windows Control Panel. See the online
Windows QuickStart Guide or Using Windows 95 for instructions on
using the Control Panel.
To connect a parallel printer to your NEC Versa 2000, do the following.
Check that both the NEC Versa and printer power are off.
1.
2.
Open the left-rear cover of the system and locate the printer port.
3.
Align and connect the 25-pin printer cable connector to the parallel port
on the system. (The parallel printer port is the third from the left.) Secure
the cable with the screws provided.
2-10 Learning to Use the Hardware
When you connect a printer, be sure you install the appropri-
Parallel Printer
Connector
Parallel Port
Connecting a parallel printer
Advertisement
Table of Contents
