Table of Contents
Advertisement
5.
Replace the memory compartment cover.
Run Auto Setup to check the new configuration. Auto Setup should show a
blinking arrow next to the extended memory field. The new value should re-
flect the increase in memory. (Refer to "Using Auto Setup" in the online Ad-
vanced Topics.)
External Monitor
You can add a standard external monitor to your NEC Versa 2000. You
need a display signal cable (usually provided with the monitor). One end of
the cable must have a 15-pin connector for the system. (See the back of the
NEC Versa 2000, behind the right-rear cover, for the monitor connector.)
Follow these steps to connect an external monitor to your NEC Versa 2000.
Check that the NEC Versa 2000 is in Suspend mode or powered off and
1.
the monitor power switch is turned off.
NOTE
while the monitor is being connected.
2-8 Learning to Use the Hardware
The NEC Versa must be in Suspend mode or powered off
Inserting a memory card
Advertisement
Table of Contents
Need help?
Do you have a question about the VERSA 2000 and is the answer not in the manual?