Table of Contents
Advertisement
MESSAGE
Diskette read failure –
press
to run Auto
F1
Setup. Press any other
key to retry boot
Non-system disk or
disk error; replace
and press any key
when ready
No boot device
available – press
F1
to run Auto Setup
Invalid configuration
information – run
Setup program
Real time clock
failure
Time-of-day not set –
run Setup program
Fixed disk
configuration error
Fixed disk failure
5-4 Solving Problems
POST Error Messages
WHAT TO DO
If there's still a problem, drive A might need repair.
Remove the diskette from drive A and press
start the system from the hard disk.
Or, insert a bootable disk in drive A and press
Remove the diskette from drive A and press any
key to start the system from the hard disk.
Or, insert a bootable disk in drive A and press
any key.
Press
to start Auto Setup. Change the hard
F1
disk type to the correct setting. Exit and save
Auto Setup.
One or more system configuration parameters
are not properly set. Start Auto Setup, set
them correctly, and exit and save to update
the parameters.
Set time and date using Auto Setup. Exit and save
to update the parameters.
Set the time and date using Auto Setup. Exit and
save Setup to update the parameters.
Start Auto Setup. Exit and save to update the
parameters. Check to see if the hard disk connector
is seated properly. If there is still a problem, the
hard disk might need repair.
Press F1 to start Auto Setup. Exit and save to
update the parameters.
Check to see if the hard disk connector is seated
properly.
If there is still a problem, the hard disk might
need repair.
to
F1
.
F1
Advertisement
Table of Contents
