Table of Contents
Advertisement
Interface
Reset to the factory default configuration. Keep the device powered on, and insert a needle
Reset
into the hole for 3 seconds, then release it. The deivce is reset to the factory default
configuration.
Power switch, power on or power off the device.
1.4 System Requirements
Recommended system requirements are as follows:
A 10/100 base-T Ethernet card is installed on your PC
A hub or Switch (connected to several PCs through one of Ethernet interfaces on the device)
Operating system: Windows Vista, Windows XP, Windows 2000, Windows ME, or Windows 98SE
Internet Explorer V5.0 or higher, Netscape V4.0 or higher, or Firefox 1.5 or higher
1.5 Features
The device supports the following features:
Compatible with IEEE 802.11b/g standard
High-speed wireless data transfer: up to 54 Mbps
Various line modes
External PPPoE dial-up access
Internal PPPoE and PPPoA dial-up access
Zero installation PPP bridge mode (ZIPB)
1483 Briged, 1483 Routed, and MER access
Multiple PVCs (up to eight) and these PVCs can be isolated from each other
A single PVC with multiple sessions
Multiple PVCs with multiple sessions
Binding of ports with PVCs
802.1Q and 802.1P protocol
DHCP server
NAT and NAPT
Static route
Firmware upgrade: Web, TFTP, and FTP
Reset to factory defaults through the Reset button or Web
DNS relay
Virtual server
DMZ
IP address mapping
Web interface
Function
3
Advertisement
Table of Contents
