Table of Contents
Advertisement
Connection Type
VPI
VCI
The procedure for configuring the ADSL settings of the router is as follows:
Step 1 Select the country where you are from the drop-down list.
Step 2 Select the corresponding ISP from the drop-down list.
After the selection, the protocol, connection type, VPI, VCI are displayed.
Step 3 Enter the correction information for dial-up.
There are six protocols available: PPPoE, PPPoA, 1483 MER: DHCP, 1483 MER: Static IP, 1483 Bridged, and
1483 Routed.
Select Belgium and Belgacom ISDN from the corresponding drop-down lists, and the page as shown in the
following figure appears.
PPPoE
In this example, select PPPoE as the protocol.
The following table describes the parameters in this page:
Field
Protocol
Connection Type
VPI
VCI
Select the connection type provided by your ISP from the drop-down list box.
You can choose LLC or VC-Mux.
VPI is the virtual path between two points in an ATM network. Its valid value is
in the range of 0 to 255.
VCI is the virtual channel between two points in an ATM network. Its valid value
is in the range of 32 to 65535. (0 to 31 is reserved for local management of ATM
traffic)
There are six protocols available. In this example, PPPoE is the protocol for dial-up.
There are two connection types available: VC-Mux and LLC. In this example, LLC is
the connection type.
Virtual path identifier (VPI) is the virtual path between two points in an ATM network.
Its valid value is in the range of 0 to 255. In this example, VPI is set to 0.
Virtual channel identifier (VCI) is the virtual channel between two points in an ATM
Description
11
Advertisement
Table of Contents
