Table of Contents
Advertisement
After entering correct VPI and VCI, DHCP automatically assigns the WAN IP address, gateway and DNS.
1483 MER: Static IP
Select 1483 MER: Static IP as the protocol, and the page as shown in the following page appears.
The following table describes the parameters in this page:
Field
Protocol
Connection Type
VPI
VCI
IP Address
Subnet Mask
Default Gateway
Primary DNS Server
1483 Bridged
Select 1483 Bridged as the protocol, and the page as shown in the following figure appears.
There are six protocols available. In this example, 1483 MER: Static IP is the protocol
for dial-up.
There are two connection types available: VC-Mux and LLC. In this example, LLC is
the connection type.
Virtual path identifier (VPI) is the virtual path between two points in an ATM network.
Its valid value is in the range of 0 to 255. In this example, VPI is set to 8.
Virtual channel identifier (VCI) is the virtual channel between two points in an ATM
network. Its valid value is in the range of 32 to 65535 (0 to 31 is reserved for local
management of ATM traffic). In this example, VCI is set to 35.
Enter the IP address for WAN connection, which is provided by your ISP.
Enter the subnet mask of the WAN IP address, which is provided by your ISP.
Enter the default gateway, which is provided by your ISP.
Enter the DNS server, which is provided by your ISP.
Description
13
Advertisement
Table of Contents
