Wlan; Basic Settings - SMC Networks 7904WBRB4 User Manual

Field
Modify Assigned IP
Delete Assigned IP
Close
MAC-based Assignment Table

3.5 WLAN

In the navigation bar, click WLAN. The WLAN page that is displayed contains Basic Settings, Security, Advance
Settings, Access Control, and WDS Settings.
3.5.1

Basic Settings

Choose WLAN > Basic Settings, and the page as shown in the following figure appears. In this page, you can
configure the parameters for wireless LAN clients that may connect to your access point.
The following table describes the parameters and buttons in this page:
Field
Disable Wireless
Interface
Band
Mode
(Root) SSID
Set VSSID
Select a row in the MAC-base Assignment Table. The MAC address and IP
address appear. After modifying the MAC address and IP address, click it to save
the settings.
Select a row in the MAC-base Assignment Table, and click it. Then this row is
deleted.
Click it to close this page.
It shows the assigned IP address based on the MAC address.
LAN Select the checkbox, you can not configure the parameters in this page. Normally.
It is not selected.
Select the working mode of the router. You can select 2.4 GHz (B), 2.4 GHz (G),
or 2.4 GHz (B+G). By defaut, the band is 2.4 GHz (B+G).
Select the WLAN mode of the router, which is varied according to the software.
You can select AP or AP+WDS. By defaut, the WLAN mode of the router is AP.
The service set identification (SSID) is a unique name to identify the router in the
wireless LAN. Wireless stations associating to the router must have the same
SSID. Enter a desciptive name. By default, the SSID is SMC.
Click it, the Virtual SSID Setting page appears. In this page, you can enable up to
Description
Description
24