The following table describes the parameters and buttons in this page:
Field
Protocol
ATM VCC
Login Name
Password
Authentication Method
Connection Type
MTU
IP Address
It displays the protocol type used for this WAN connection. In this
example, it is PPPoE.
It displays the ATM virtual circuit connection assigned for this PPP
interface (VPI/VCI).
The login name provided by your ISP.
The password provided by your ISP.
You can select AUTO, CHAP, or PAP.
You can select Continuous, Connect on Demand, or Manual.
Continuous: After dial-up is successful, PPP connection is always
on-line, no matter whether the data is being transmitted or not.
It is recommended to select it.
Connect on Demand: After dial-up is successful, within the preset
idle time, no data is being transmitted, the router automatically
disconnects the PPP connection.
In this case, you need to enter the idle time.
Manual: Select it, you need to dial up and disconnect the connection
mannually.
Maximum transmission unit (MTU) is the largest size packet or frame,
specified in octets (eight-bit bytes), that can be sent in a packet- or
frame-based network such as the Internet. Transmission Control Protocol
of the Internet uses the MTU to determine the maximum size of each
packet in any transmission.
You can select Dynamic IP or Static IP.
If you select Dynamic IP, the IP address for PPPoE dail-up is
33
Description