The procedure for configuring DMZ is as follows:
Step 1 Select Enable DMZ to enable DMZ.
Step 2 Enter the IP address of the DMZ host.
Step 3 Click Apply Changes to save the settings in this page.
3.7.4
Routing
Choose Advanced > Routing. The Routing page that is displayed contains Static Route and RIP.
3.7.4.1 Static Route
Click Static Route, and the page as shown in the following figure appears. In this page, you can configure the
routing information. You can add or delete IP routes.
The following table describes the parameters and buttons in this page:
Field
Enable
Destination
Subnet Mask
Next Hop
Metric
Interface
Add Route
Select the checkbox to use static IP routes.
Enter the IP address of the destination device.
Enter the subnet mask of the destination device.
Enter the IP address of the next hop in the IP route to the destination device.
The metric cost for the destination.
Select the interface for the specified route.
Click it to add the new static route to the Static Route Table.
Description
41