RANGE HOOD CARE
CLEANING
WARNING
•
To reduce the risk of electrical shock, DO NOT
clean the hood while it's operating.
•
Never put your hands into the area housing the
fan when the fan is operating.
Cleaning the Exterior Surfaces:
IMPORTANT
To avoid damage to the exterior surfaces:
•
DO NOT use corrosive or abrasive detergent.
•
DO NOT use steel wool, scoring pad or steel
brushes. Use a paper towel or soft cloth or
nonabrasive sponge instead.
•
DO NOT use salt solutions, disinfectants,
bleaches or cleaning compound that contains
harmful chemicals.
Cleaning Method:
•
Noncorrosive or nonabrasive liquid detergent
soap or all-purpose liquid cleanser.
•
Wipe the surfaces with a damp paper towel or
soft cloth or nonabrasive sponge.
•
Rinse with clean water.
•
Wip dry with dry towel or cloth.
Note
•
The nonabrasive stainless steel polisher can
be applied when done cleaning to retain the
stainless luster and grain.
•
Always follow the instrunction of the polisher.
Cleaning the Stainless Steel Baffle Filters:
•
Pull the spring release handle and remove the
filter by pulling it down.
• Wash the filters in the dishwasher, or soak it
into hot or warm water with dish detergent for
half an hour, then wipe the filter clean. Repeat
these steps until there's no oil residue remains.
•
Let the filters dry thoroughly.
•
Make sure the spring release handle is toward
the front, align and insert the filter.
•
Pull the spring release handle and push the
filter into position.
•
Release the handle.
•
Repeat the steps for the remaining filters.
REPLACING THE FILTERS
•
Replace the baffle filters immediately should
they become worn out due to aging or
prolonged usage.
REPLACING THE LED LAMPS
WARNING
Electrical Shock Hazard
Disconnect power before servicing
Wear gloves to protect against sharp edges
•
This range hood uses 120V LED. (Model No.:
GU10.)
•
Unplug the range hood, or turn off the breaker.
•
Press on the rim of the Lamp and twist
counter-clockwise to unlock the Lamp.
•
Pull out the deffetive Lamp. Use a flathead
screwdriver if needed.
•
Align and put the new Lamp back into position.
•
Press on the rim of the new Lamp and twist
clockwise to lock the Lamp in position.
•
Plug in the range hood, or turn on the breaker.
•
Check if the new Lamp is working properly.
11
Need help?
Do you have a question about the RH-S10-MS and is the answer not in the manual?