Prestigio Multiboard Light+ PSMB068P110 Quick Start Manual page 10

Operation
 Make conference calls using the built-in microphones (I-7) and video camera (I-1). You can also connect an external video camera
and microphone;
NOTE. To use the conference call function, you should install the corresponding application from an online resource or from a flash
drive.
 Play and process data using the File Manager and pre-installed applications;
 Create and edit text and graphic objects on the interactive panel screen using your fingers or stylus. Up to 20 simultaneous action
points are available;
 Perform proximity user identification using the NFC sensor (I-8). Bring your ID card with the "NFC" tag to the sensor. Data can be
readout from up to 30 cm;
 To work with OS Windows-based files and applications, install a mini computer in the interactive panel slot (I-12). To start
operation, the mini computer must be selected as the signal source (see also the instructions for the mini computer).
NOTE. Mini computer is not included in the package.
ATTENTION! Use only mini computers recommended by the manufacturer (models PMB528K001, PMB528K002, PMB528K003,
PSMB528K001) for this interactive panel.
Shut down
When you are finished using the interactive panel, close all applications. Next, finish the interactive panel operation in one of the
following ways:
 Put the device in standby mode by pressing once the power button (I-10) of the interactive panel or the button (II-1) of the RC
unit (pressing one of these buttons again puts the interactive panel in operation mode);
 Turn the power toggle switch (I-29) to position O ("Off").
NOTE. For more information about the interactive panel functionality, see the full user manual for the device at prestigio-
solutions.com.
Troubleshooting
1. Power button indicator does not light up and the interactive panel does not turn on: the power supply is faulty. Connect the
interactive panel to another mains socket. Check that the mains are in good working order.
2. Interactive panel responds to the remote control buttons only from a short distance or not at all:
 There is an obstacle between the IR receiver and the remote control. Remove the obstacle to the remote control signal;
 Batteries in the remote control are discharged. Replace the batteries.
3. Image on the screen has a dotted line or stripe: there is an electrical appliance nearby that is causing interference. Remove the
source of interference or move the interactive panel.
4. There is no image on the screen, touch control does not work – there is no contact with an external device or a mini computer
installed in the interactive panel:
 Signal source cable does not match the interface of the interactive panel. Check that the cable matches the interface;
 Mini computer is not properly connected to the interactive panel. Make sure that the mini computer is inserted into the slot as
far as it will go and that the screws are securely tightened. If necessary, disconnect the mini computer and reinsert it into the slot,
tighten the screws.
5. Interface on the screen "freezes" or does not respond:
 Too many programs are running at the same time. Turn off the power to the device for 1–2 minutes and turn it on again;
 The firmware and/or the application you are using is out of date. Update the device firmware and/or application to their latest
versions.
6. Touch control is offset: a failure occurred in the coordinate system of the device. Contact a service center to calibrate the display.
ATTENTION! If none of the suggested solutions solve the problem, contact your supplier or an authorized service center (see
prestigio-solutions.com/warranty for centers' addresses). Do not disassemble the device or attempt to repair it yourself.
SIMPLIFIED DECLARATION OF CONFORMITY
ASBISC hereby declares that the device complies with Directive 2014/53/EU. The full text of the EU Declaration of Conformity is
available at the following web address: files.prestigio-solutions.com/documents/certificates/multiboards.
10
PSMB068P110
© 2024 Prestigio Solutions