Nexcom DNA 141 User Manual page 49

Chapter 4: BIOS Setup
ME Debug Configuration
This section is used to configure the ME debugging.
HECI Timeouts
Enable or disable HECI sending/receiving timeouts.
Force Me DID Init Status
Enable or disable the Force ME DID initiating status.
CPU Replaced Polling Disable
Enable or disable the CPU replaced polling.
HECI Message Check Disable
Enable or disable HECI message checking.
MBP HOB Skip
Enable or disable the MBP HOB skipping.
Copyright © 2024 NEXCOM International Co., Ltd. All Rights Reserved.
HECI2 Interface Communication
Enable or disable the HECI2 interface communication.
KV Device
Enable or disable usage of the KV device.
End of Post Message
Set the message to display after the POST.
DOI3 Setting for HECI Disable
Enable or disable the DOI3 setting while HECI is disabled.
MCTP Broadcast Cycle
Enable or disable the MCTP broadcast cycle.
36
DNA 141 User Manual