Nexcom DNA 141 User Manual page 46

Chapter 4: BIOS Setup
GT - Power Management Control
This section is used to configure the GT power management features.
RC6 (Render Standby)
Check to enable render standby support.
Maximum GT frequency
Configure the default setting of Maximum GT frequency.
Disable Turbo GT frequency
Enable or disable the feature of Turbo GT frequency.
Copyright © 2024 NEXCOM International Co., Ltd. All Rights Reserved.
PCH-FW Configuration
This section is used to configure the PCH-FW Configuration features.
ME State
Enable or disable the ME state.
ME Unconfig on RTC Clear
Enter or disable the feature of ME Unconfig on RTC Clear.
Comms Hub Support
Enable or disable the feature of Comms Hub Support.
JHI Support
Enable or disable th JHI Support.
Core BIOS Done Message
Enable or disable the message popup after the Core BIOS is done.
33
DNA 141 User Manual