Figure 35 Wireless Security Setup: Wep Encryption; Table 22 Wireless Security Setup: Wep Encryption - ZyXEL Communications P-330W - V1.90 User Manual

Chapter 6 Wireless
Table 21 Wireless Security Setup: Static WEP Encryption
LABEL
Port
IP Address
Password
Save
Reset
Click SET WEP KEY to configure WEP encryption.

Figure 35 Wireless Security Setup: WEP Encryption

The following table describes the wireless LAN security labels in this screen

Table 22 Wireless Security Setup: WEP Encryption

LABEL
Key Length
Key Format
Default Tx Key
Encryption Key
1 to 4
Passphrase
Save
68
DESCRIPTION
The port number on the RADIUS server.
Enter the IP address of the RADIUS server.
Enter the password (shared secret) for the RADIUS server.
Click Save to save your changes back to the P-330W.
Click Reset to reload the previous configuration for this screen.
DESCRIPTION
Select 64-bit WEP or 128-bit WEP.
ASCII: Select this option in order to enter ASCII characters as WEP key.
Hex: Select this option in order to enter hexadecimal characters as a WEP key.
You must configure at least one key, only one key can be activated at any one time.
The default key is key 1.
The WEP keys are used to encrypt data. Both the P-330W and the wireless stations
must use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal
characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal
characters ("0-9", "A-F").
Enter a Passphrase (up to 32 printable characters) and clicking Generate WEP KEY.
The P-330W automatically generates a WEP key.
Click Save to save your changes back to the P-330W.
P-330W User's Guide