Wpa(2)-Psk; Figure 63 Wireless: Static Wep Encryption; Table 37 Wireless: Static Wep Encryption - ZyXEL Communications P-2608HWL-Dx Series User Manual

P-2608HWL-Dx Series User's Guide

Figure 63 Wireless: Static WEP Encryption

The following table describes the wireless LAN security labels in this screen.

Table 37 Wireless: Static WEP Encryption

LABEL
Security Mode
Passphrase
WEP Key

9.5.3 WPA(2)-PSK

In order to configure and enable WPA-PSK authentication; click Network > Wireless LAN to
display the General screen. Select WPA-PSK or WPA2-PSK from the Security Mode list.
126
DESCRIPTION
Choose Static WEP from the drop-down list box.
Enter a Passphrase (up to 32 printable characters) and clicking Generate. The ZyXEL
Device automatically generates a WEP key.
The WEP key is used to encrypt data. Both the ZyXEL Device and the wireless
stations must use the same WEP key for data transmission.
If you want to manually set the WEP key, enter any 5, 13 or 29 characters (ASCII
string) or 10, 26 or 58 hexadecimal characters ("0-9", "A-F") for a 64-bit, 128-bit or
256-bit WEP key respectively.
Chapter 9 Wireless LAN