Advertisement
(2) Menu "Absocoder Object (ClassID: 0x64)"
- References and settings of ABSOCODER's parameter and status
Note
When setting parameters, switch the operation mode of the host PLC to program mode (PROG).
Cannot be set in run mode (RUN).
This operation is performed by using the PLC's configuration tool (a PLC development tool software).
*: Depending on the PLC model, this operation can also be performed by the mode selection switch on the CPU card.
147
Advertisement
Need help?
Do you have a question about the ABSOCODER NCW-3DHIPLC and is the answer not in the manual?