Advertisement
7. Software Installation
To configure the
3PE TP software
Installation Guide
1.
On PolyScope, in the Header, tap Installation and select Safety.
2.
Tap Hardware and unlock the options on the Select available hardware
screen.
A password is required to unlock this screen.
3.
In the Teach Pendant drop-down list, select 3PE Enabled.
4.
Tap Apply to restart the system. PolyScope continues to run.
5.
Tap Confirm Safety Configuration to complete the 3PE Teach Pendant
software installation.
6.
As the robot restarts and initializes, light-press the 3PE button and tap Start on
PolyScope.
Teach Pendant with 3-Position
Enabling Device
Advertisement
Need help?
Do you have a question about the 3PE Teach Pendant and is the answer not in the manual?
Questions and answers