Wren Kitchens Base Unit 972 Corner Base Fittings Manual page 9

Adjusting the hinge
To adjust the hinges, use a screwdriver as
required at points 1 and 2.
Point 1 -Will adjust the frontals left and right.
Point 2 - Will adjust the frontals in and out.
Point 3 - Will adjust the height of the frontal.
Re-tighten the screw.
Fitting the hinge cover cap
Fit the hinge cover caps to the hinges by
pressing down to secure.
Cleaning the unit
Finally, the unit should be thoroughly
cleaned to remove any debris that may have
accumulated during the installation.
These will be used later when installing the worktop (laminate or timber).
Store the plinth clips and the remaining 15mm screws.
These will be used later when attaching the plinth.
Store the L-brackets.
Page 9