Wren Kitchens Base Unit 972 Corner Base Fittings Manual page 5

Drilling the pilot hole
Drill a pilot hole through the back panel
making sure to lightly mark the wall to
indicate where the wall fixing should be
placed. The hole should be located as per the
diagram, in the centre and close to the top of
the unit.
For guidance on the appropriate wall fixing
for each wall type, please consult the "Room
Preparation Guide."
Once complete lift and move the unit away
from the wall.
Using the pilot hole, drill a hole to suit the
fixing. Place the wall fixing within the hole.
Lift and reposition the unit, ensuring it is level
and in line with the wall markings.
Inserting the space plugs
Position the space plugs between the wall
and the back of the unit, where the holes are
located.
Unwind until the space plugs touches both
the back panel of the unit and the wall.
Insert the screws into the drilled holes and
tighten to the wall.
XL Space
Page 5