Wren Kitchens Base Unit 972 Corner Base Fittings Manual page 4

Notching out the side panels (when
required)
In order to allow for any horizontal pipework
running behind the unit, some units will
require the back of unit's side to be notched
out.
Create a notch for the horizontal pipes at the
back of the end panels using a jigsaw.
Lifting the unit into place
When lifting the unit into place do not tilt as
this can damage the legs.
Place the unit against the wall and align it
with the wall markings that will have been
drawn during the room preparation stage.
Use a spirit level to ensure the unit is
level from front to back, left to right, and
diagonally. Adjust the legs if required.
The leg height can be adjusted by turning the
foot of the leg clockwise or anti-clockwise.
No screws or wall plugs are provided for attaching the unit to the wall.
Before drilling into the wall you MUST check for any hidden services or pipework within the walls.
Drilling the pilot holes
Drill 2 pilot holes through the back panel
making sure to lightly mark the wall to
indicate where the wall fixing should be
placed. The holes should be located as per
the diagram, 1/3 in from each side and close
to the top of the unit.
For guidance on the appropriate wall fixing
for each wall type, please consult the "Room
Preparation Guide."
This is due to variations in wall construction.
Page 4