Network Failure - Sanyo VCC-HD5400 User Manual

Click RECORDING in the configuration menu to display the RECORDING screen.
Configure the recording conditions on this screen if you intend to record video on a SD memory card installed in
the camera or an external hard disk drives.
Required operation privilege: admin, operator1
1
In [RECORD STREAM], select the stream you want to record for each recording mode.
Available streams for each recording mode are displayed based on the [RECORDING] settings on the VIDEO &
AUDIO SETTINGS screen.
The pull-down menu displays the image conditions of the selected stream.
OFF (no recording), STREAM1, STREAM2, STREAM3, STREAM4
You need to configure the video conditions for each stream on the VIDEO & AUDIO SETTINGS
screen.
NORMAL:
Normal live video is recorded.
If [PRE ALARM] under [NETWORK FAILURE] or [ALARM EVENT] is enabled, this is fixed at "OFF"
and cannot be changed.
ALARM:
Alarm video is recorded.
Configure the recording conditions in [ALARM EVENT1] to [ALARM EVENT4] (step

NETWORK FAILURE:

If a network failure occurs during network recording, backup recording is performed until the failure is resolved.
Configure the following backup recording conditions. See the description of [ALARM EVENT] (step
details on [FRAME RATE], [PRE ALARM] and [DURATION].
A NETWORK FAILURE
This is the time from the occurrence of a network failure until the camera recognizes it as a trigger.
15SEC, 20SEC, 30SEC, 40SEC, 50SEC, 1MIN, 2MIN, 3MIN, 4MIN, 5MIN
The setting values are interlocked among RECORDING, E-MAIL SETTINGS, and FTP SETTINGS
screens. (Note that the setting configured most recently will take precedence.)
B
FRAME RATE
C
PRE ALARM
D DURATION
4 ).
Working with Administrator Configuration Screens 59/79
4 ) for