Sanyo VCC-HD5400 User Manual page 102

A TO B: Detects object movement from A to B.
B TO A: Detects object movement from B to A.
A TO B, B TO A: Detects object movement between A and B, in both directions.
(Ex. Appearance of detection
line)
* For the size and direction of the object to be detected when you selected [AREA], refer to the above figure on the
right.
In [SENSITIVITY], select the detection sensitivity.
4
You can adjust the detection sensitivity to prevent unwanted detection.
The higher the value, the lower the sensitivity.
1 (HIGH) to 9 (LOW)
Click to check how the motion sensor works with the current settings.
5 TEST
If any motion is detected with respect to the detection line (or detection area), that line will be shown in red.
Correct the detection conditions as required.
While the sensor is working, this button is labeled as
click the button.
During the test, you cannot change line/area settings.
Configure the output conditions of alarm output terminals for each alarm output number.
A Configuring automatic
alarm output:
B
Configuring remote alarm
output:
If you configure this function, connect an alarm output cable for the camera.
For details, refer to the "Alarm Cable Connection" section.
(Ex. Appearance of detection
area)
Configure the terminal so that it outputs an alarm signal automatically when
an alarm condition is detected.
Configure the terminal so that it outputs an alarm signal when the
corresponding Remote Alarm button is clicked.
END . To finish checking the motion sensor,
Working with Administrator Configuration Screens 56/79