Sanyo VCC-HD5400 User Manual page 99

8
In [SENSITIVITY], select the detection sensitivity.
You can adjust the detection sensitivity to prevent unwanted detection.
The higher the value, the lower the sensitivity.
1 (HIGH) to 9 (LOW)
9
In [FACE DETECTION], select "ON" to use the face detection function.
The face detection function judges whether or not the subject includes any intruder by detecting his/her face.
If a human face is detected in the detection area when motion is detected, the motion sensor will send a motion
alarm.
A human face may not be detected if obscured by a hat, sunglasses, or mask, or if the monitoring
angle is not appropriate.
Checking how the motion sensor works
Click SET to determine the configured contents, and then click
If any motion is detected in a grid cell in the detection area, that cell will be shown in red.
Correct the detection conditions as required.
While the sensor is working, this button is labeled as
click the button.
10
Click and then
SET
The settings are saved and you return to the ALARM SETTINGS screen.
You can set lines or areas that represent limit lines or restricted areas on the screen and detect motion that
crosses those lines or moves in and out of those areas.
You can configure this function for the screens corresponding to the preset positions 1 through 8
only.
This function is available only for streams for which you set [CODEC] to "H.264" on the VIDEO &
AUDIO SETTINGS screen.
.
BACK
TEST ( 2 ).
END
. To finish checking the motion sensor,
Working with Administrator Configuration Screens 53/79