Sanyo VCC-HD5400 User Manual page 96

5
Select how you want the camera to behave upon receiving alarm input (ACTION).
OFF: Disables the camera action when an alarm signal is input.
PRESET: Upon receiving an alarm input, the camera moves to the preset position that has the same
number as the alarm number.
To use this function, you must first configure preset positions so that their numbers correspond
to those of alarm input.
SEQ1-4: Starts the operation in the sequential modes 1 to 4.
PAN1-4 Starts the operation in the auto pan modes 1 to 4.
TOUR1-4 Starts the operation in the tour modes 1 to 4.
6
Specify whether or not to return to the previous operating conditions upon completion of
an alarm action (RETURN).
OFF: Keeps the current condition after receiving an alarm input.
ON: Returns to the previous operating conditions before an alarm action took place (AUTO RETURN).
If you set [RETURN] to "ON", the system will return to the previous operating conditions before an
alarm action took place, when the alarm duration (DURATION) expires.
If another alarm input is received during the time specified in the [DURATION] setting, an action will
be made according to the last alarm received.
If the system is powered off while an alarm action is taking place, it will restart in either of the
following modes when turned on:
When [RETURN] is set to "ON": Restarts to perform the previous operating conditions before an
alarm was received.
When [RETURN] is set to "OFF": Restarts to perform the alarm action that is specified in
[ACTION].
Follow the same steps to configure the alarm inputs 2 - 4.
To set the system not to receive any alarm signal during the PTZ operation and for a specific time after the
operation, select the alarm-disabled period after PTZ operation from the pull-down menu in [ALARM DISABLE] at
the lowermost part of the ALARM SETTINGS screen.
This setting will be applied to all the alarm signals, regardless of whether they are detected via alarm input
terminals or the built-in motion sensor.
OFF, 1MIN, 2MIN, 3MIN, 4MIN, 5MIN, 6MIN, 7MIN, 8MIN, 9MIN, 10MIN
This camera offers the built-in motion sensor function that automatically detects motion in the subject.
The motion sensor detects an alarm condition in two ways as follows.
A Detecting motion in specific areas
B Detecting motion with lines and areas drawn on the screen
Working with Administrator Configuration Screens 50/79