Sanyo VCC-HD5400 User Manual page 93

1
Click to view the PTZ controller.
PTZ
2
Select "1" for [AUTO PAN].
3
Use the controller to specify the start position while monitoring live video displayed on
the monitor, and click
The start point has been specified.
4
Specify the end point in the same manner, and click
The end point has been specified.
5
Set the pause period at the start and end points.
1SEC, 2SEC, 3SEC, 4SEC, 5SEC, 10SEC, 20SEC, 30SEC
6
Configure the panning direction.
LEFT (counterclockwise), RIGHT (clockwise)
7
Select a movement speed and click
You can confirm the movement speed by clicking
necessary.
1 (slow) to 15 (quick)
Now the settings for the auto pan 1 have been stored.
You can follow the same steps to configure for the auto pans 2 to 4.
Running the Stored Auto Panning Operation
In [AUTO PAN], select a registration number and click
Auto panning operation starts at the start point with specified tilt, focus and zoom conditions.
Auto focus works only when the camera moves slowly or it pauses at the end point for more than five
seconds.
You can configure up to four patterns of sequential operations such as panning, tilting and zooming.
1
Click to view the PTZ controller.
PTZ
2
Select "1" for [TOUR].
3
Click , and then
START
The system starts recording a tour operation.
.
START
.
SET
TEST
. A test operation starts; change the setting values as
RUN
in the confirmation dialog box.
YES
END .
to run the specified operation.
Working with Administrator Configuration Screens 47/79