Roland XV-5050 Owner's Manual page 89

54: DISTORTION 2
This is a distortion effect that provides heavy distortion. The
parameters are the same as for "53: OVERDRIVE 2."
fig.02-054m
L in
Amp
Distortion
Simulator
R in
55: STEREO COMP
fig.02-055m
L in
Compressor 2-Band EQ
R in
Compressor
2-Band EQ
Parameter Value
Attack 0-127
Sustain 0-127
Post Gain 0, +6, +12,
+18 dB
Low Gain -15-+15 dB
High Gain -15-+15 dB
Level # 0-127
56: St LIMITER (Stereo Limiter)
fig.02-056m
L in
Limiter 2-Band EQ
R in
Limiter
2-Band EQ
Parameter Value
Threshold 0-127
Ratio 1.5:1, 2:1, 4:1,
100:1
Release 0-127
Post Gain 0, +6, +12, +18
dB
Low Gain -15-+15 dB
High Gain -15-+15 dB
Level # 0-127
L out
Pan L
2-Band
EQ
Pan R
R out
(Stereo Compressor)
L out
R out
Description
Sets the speed at which compression
starts
Adjusts the duration of the compres-
sion.
Adjusts the output gain.
Gain of the low frequency range
Gain of the high frequency range
Output level
L out
R out
Description
Adjusts the volume at which com-
pression begins.
Compression ratio
Adjusts the time from when the
volume falls below the Threshold
Level until compression is no long-
er applied.
Adjusts the output gain.
Gain of the low frequency range
Gain of the high frequency range
Output level
Chapter 4 Using the XV-5050 Effects
57: GATE
Cuts the reverb's delay according to the volume of the sound sent
into the effect. Use this when you want to create an artificial-
sounding decrease in the reverb's decay.
fig.02-057m
L in
Gate
R in
Gate
Parameter Value
Mode GATE, DUCK
Attack 0-127
Hold 0-127
Release 0-127
Key SOURCE, A, B
Threshold 0-127
Monitor OFF, ON
Balance # D100:0W-
D0:100W
Level 0-127
L out
R out
Description
Type of gate
GATE (Gated Reverb): When the source
volume falls below a certain level, the gate
closes, cutting off the tail of the reverb.
DUCK (Ducking Reverb): When the
source volume gets high enough, the gate
closes, creating a ducking reverb-type ef-
fect. The reverb stops when the input sig-
nal becomes so loud that the sound
becomes unclear.
Adjusts the time it takes for the gate to
fully open after being triggered.
Adjusts the time it takes for the gate to
start closing after the source sound falls
beneath the Threshold.
Adjusts the time it takes the gate to ful-
ly close after the hold time.
Selects the source sound that acts as the
trigger for closing the gate.
SOURCE: The gate is closed by the sound
sent into the Multi-effects.
A, B: The gate is closed by the direct
sound sent to the OUTPUT A or OUTPUT
B jacks
Volume level at which the gate begins
to close
Determines whether the sound used as
the gate trigger is included in the effect
output (ON) or not (OFF).
* This parameter is disabled when
Key is set to SOURCE.
Volume balance between the direct
sound (D) and the effect sound (W)
Output level
89