P-Series Emulation; Set Substitution - Printronix P5000 Series User Manual

Chapter 4
LinePrinter Plus Emulation

Set Substitution

When this option is activated, the character set overlay in RAM is
activated. This can also be accomplished through a host command
of SFCC RX. In either case, a flag is set indicating that the
substitution table is active. If the power-up configuration has Ld Set
at Pwrup and Set Substitution both enabled, the character set
overlay is automatically activated at power-up or during a soft reset.
See the LinePrinter Plus Programmer's Reference Manual for more
information.

P-Series Emulation

Printer
Protocol
(from page 164)
P-Series
Control Code
Control Code
06 08
8.0 LPI*
Elongated*
10.3 LPI Backspace
6.0 LPI
Select VFU Select
SFCC
1* EVFU*
(0-7F hex) DVFU
CVFU
Disable
FF valid
at TOF
Enable*
Disable
172
Auto LF
Define CR
Code
CR = CR* Disable*
CR = CR + LF Enable
Alt. Set Character
80-9F Set
Control Code* (see page 177) Even dot plot*
Printable
* = Factory Default
Overstrike Define LF
Code
Enable* LF = CR + LF*
Disable LF = LF
PSeries Dbl
SFCC d
Command High
Normal*
Double high P3/4/6/9 Compat