Printronix P5000 Series User Manual page 224

Chapter 4
HOST INTERFACE
Latch Data On
Specifies whether the data is read on the leading or trailing edge of
the data strobe signal.
Prime Signal
•
•
TOF Action
•
•
Buffer Size in K
Configures the amount of memory allocated for the Centronics
parallel port buffer. You can specify between 1 and 16 Kbytes, in
1-Kbyte increments.
224
Enable. The parallel port will perform a warm start (reboot) if
the host asserts the prime signal.
Disable. The parallel port will not perform a warm start (reboot)
if the host asserts the prime signal.
Reset. A form feed is performed before a warm start when the
prime signal is asserted from the host. This setting is used only
if the prime signal parameter is enabled.
Do Nothing. Nothing occurs before a warm start when the
prime signal is asserted from the host.