Printronix P5000 Series User Manual page 40

Chapter 2
Connect The Interface And Power Cables
I/O Cable
6. Hold the I/O cable below its connector and gently push the
cable through the opening in the grommet seated in the notch.
7. Pull the cable up through the notch until it reaches the I/O plate.
Attach the cable connector to the printer interface connector
previously selected in step 4 of this section.
8. Secure the cable to the printer using the upper and lower
standoffs.
9. Guide the power cord up through the hole in the lower right
back corner of the cabinet (see Figure 21). Thread the power
cord inside the bracket where the gas spring is attached.
10. Plug the power cord into the printer AC power connector, then
into the AC power outlet.
40
Figure 22. Routing the I/O Cable
Grommet