Printronix P5000 Series User Manual page 52

Chapter 2
Install Basic Components
Figure 35. Set the Forms Thickness Lever based on the Paper Thickness
14. Lower the forms thickness lever, and set it to match the paper
thickness. (The A-B-C scale corresponds approximately to
1-, 3-, and 6-part paper thickness.)
NOTE: Do not set the forms thickness lever too tightly; excessive
15. For pedestal models with the Quick Access Cover, see Figure
31 on page 48 for paper exiting options. For all other pedestal
models, manually feed the paper through the rear paper exit by
using the vertical position knob.
NOTE: For cabinet models with the power paper stacker installed,
52
Forms Thickness Lever
friction can cause paper jams, ribbon jams (with potential
for ribbon damage), smeared ink, or wavy print.
go to "SureStak Power Paper Stacker" in the next section.
For all other cabinet models, go to "Set The Top-of-Form"
on page 60.