Burners; Gnffers; Control Knobs-Cooktop And Oven - DCS RGSC-305BK Use And Care Manual

CARE AND MAINTENANCE
BURNERS
For proper lighting and performance keep the burners dean, It is necessary to dean the burners if they
do not light even though the igniter dicks, if there has been a severe boll over, or when the flame does
not burn blue,
Be certain aII burner knobs are in the OFF position before attempting to dean the burners.The burners
have been designed for ease in cHeaning.When the grates and burners are coo[, remove the grate.The
Burner Cap and the Brass Port Ring can easily be [ifted off.Wash these parts in hot soapy water, rinse
and dry thoroughHy.The Burner Caps are porceHain ename[, foHHowthe directions on the previous page
that were given for the burner
grates. A bristle brush can be used
to dean out the toothed burner
ports, if necessary. DisassembHy of
the Simmer Ring is not
recommended, however, it may
become necessary to do so if the
ports remain dogged after normaH
cleaning. If it is necessary to
disassembHe the Simmer Ring from
the Base, remove the Hex Nut at
the top of the Simmer Ring. CHean
the Simmer Ring with hot soapy
water using a soft wire or plastic
bristle brush then dry thoroughly.
Re-assemble the parts using the
Hex Nut.
After cleaning, it us important to
make sure the Locating Pin on the
bottom side of the Simmer Ring is
properly aligned with the
corresponding hole in the Base
and that the Locating Pin (see
insert) in the bottom side of the
Brass Port Ring is properly aligned
BrassRing
Locating Pin
Main
Burner
Port
Ring
Hex Nut
..... _-_-_ Simmer
Locating Ring
Notch u Locating Pin
Burner
Base
Hole Inside
Venturi
with the Locating Notch on the top side of the Simmer Ring. Incorrect alignment wiII produce a
potentially dangerous flame and poor burner performance. See the illustration.
IGNITERS
Wipe with a water-dampened cotton swab. Be careful not to damage
the igniter. (See illustration)
CONTROL KNOBS - COOKTOP AND OVEN
These are plastic and can be cleaned in hot, soapy water.To remove the
knobs from the control panel, grasp the knob and pull straight forward.
Wash, do not soak. Rinse and dry thoroughly. It is important to replace
these knobs on the correct gas valve on the control panel.
IGNITER (keep dean)
25